The wear-resistant ceramic coating construction is a relatively large project. It will be faster if it is only applied by equipment,but it will take a long time if it is a pipeline and other projects. In either case, the wear-resistant ceramic coating cannot be used immediately at the end of construction. So how long can the wear-resistant ceramic coating be used after it is applied? Let Yutong's staff explain it for everyone.

1. The wear-resistant ceramic coating does not need to wait too long when the construction is completed. The surface drying time is 2 hours and the curing time is 24 hours. In addition, when the environment is higher than 25 degrees,the curing speed will be accelerated.

2. Of course, if you want to put it into use faster, you can also appropriately shorten the coating time after mixing A and B glue. The time is about 45min. It will be used up. Generally, it can be completely cured at 24 hours and put into use .

3. Of course, if it is in winter, because of the influence of low temperature, the curing time will increase, you can use some heating and heat preservation measures, such as water-blocking heating or black light baking heating. It should be noted that if it is not completely cured, it must not be used in advance,otherwise it will be a shortfall and it will affect the use of equipment.

How long can the abrasion-resistant ceramic coating be used? The construction personnel must strictly implement it during construction. The use of abrasion-resistant coatings must be paid attention to, otherwise a situation may occur. It seems that there is no problem on the surface. Will fall off. Or the service life is very short.